Tape Map (option 4.6)

Use Tape Map (option 4.6) to print a summary (map) of the data contained on a tape. You can produce a map of the entire tape, or of a specific number of tape files.

When you select Tape Map, the Tape Map panel shown in Figure 1 is displayed.
Figure 1. Tape Map panel
 Process   Options   Help
 Z Data Tools                       Tape Map

 Tapes:  No tapes allocated

    DDNAME to use . ________     enter new name, or select one from above

 Print Options:
    Files . . . . . 1____        number of tape files, EOV, or EOD
    Blocks  . . . . 1_______     number of blocks
    Print format  . HEX_         CHAR or HEX

 Command ===> _________________________________________________________________
 F1=Help      F2=Split     F3=Exit      F4=CRetriev  F7=Backward  F8=Forward
 F9=Swap     F10=Actions  F12=Cancel

Tape Map prints from each file the number of blocks specified (in hexadecimal format or character format), followed by a summary of the space that the files take up on the tape. The output is affected by several options within Set Processing Options (option 0). These are described in Controlling print output.

Figure 2 shows sample output from Tape Map.
Figure 2. A tape map: output from Tape Map (option 4.6)
HCL Z Data Tools                                                                    6/09/2000 (2000.161) 12:56  Page 1
* * * * Device 0580, TAPEIN, VOLSER=0GB220, 9 Track, 1600-BPI,  Ring=in   Tape positioned at load point        * * * *
BLK    1   DATA   80    CHAR VOL10GB220                               GA2972A
                        ZONE EDDFFCCFFF4444444444444444444444444444444CCFFFFC44444444444444444444444444444444
                        NUMR 56310722200000000000000000000000000000000712972100000000000000000000000000000000
File 00001 has 240 bytes in 3 blks, min blk=80, max blk=80
 This file is approximately 0.5 feet (0.1 meters)
Total data mapped: 240 bytes, 3 blocks, 0.5 feet (0.1 meters)
3 block(s) mapped

For more information, refer to the online help or TMP (Tape Map).